Victron Orion-Tr Smart 12/12 30A Non Isolated DC-DC Charger – Full Installation Kit

Product Description PLEASE CHOOSE THE LENGTH OF CABLE TO BE THE MAX DISTANCE BETWEEN BATTERIES. THIS KIT INCLUDES EVERYTHING TO INSTALL AS PER THE INSTRUCTIONS FROM VICTRON – THE MOST EFFICIENT AND CORRECT WAY TO INSTALL. 1 ORI121236140 Charging Unit. * Metre – 10mm² PVC Red Main Power Cable Rated to 70 Amp at 12 Volt. 1 Metre – 10mm² PVC Black Main Earth Cable Rated to 70 Amp at 12 Volt. 1 Metre – 16mm² PVC Black Cable Rated to 110 Amp at 12 Volt. 1 Metre – Split Conduit to Protect Your Cable 2 x 8mm Post Type Battery Terminals For Connecting Your Leisure Battery. 2 x MTA Midi Fuse Holders. 4 x MTA Midi Fuses (Includes 2 Spares). 1 x Piggy Back Blade Fuse Holder. 1 x Piggy Back Mini Blade Fuse Holder. 1 x Standard Blade Fuse 1 x Mini Blade Fuse Crimp Terminals Required to Connect Your Kit. 3 x 10mm² Cord End Terminals Red and Black Heatshrink to insulate your terminals. 15 x Black Nylon Cable Ties. 10 x Adhesive Cable Tie Fixing Bases (19mm x 19mm) including fixing Screws. 2.5mm Roll Forged Drill Bit. Features Bluetooth Smart enabled Any Bluetooth enabled smart phone, tablet or other device can be used to monitor, to change settings and to update the charger when new software features become available. Fully programmable Battery charge algorithm (configurable) or fixed output. Smart alternator compatibility: engine running detection mechanism. Adaptive 3-stage charge algorithm: bulk – absorption – float For lead acid batteries it is important that during shallow discharges the absorption time is kept short in order to prevent overcharging of the battery. After a deep discharge the absorption time is automatically increased to make sure that the battery is completely recharged. For lithium batteries absorption time is fixed, default 2 hours. Alternatively, a fixed output voltage can be chosen. Remote on-off A remote on/off switch or relay contact can be connected to a two-pole connector. Alternatively, the H terminal (right) of the two-pole connector can be switched to battery plus, or the L terminal (left) of the two pole connector can be switched to battery minus (or the chassis of a vehicle, for example). All models are short circuit proof and can be paralleled to increase output current An unlimited number of units can be connected in parallel. High temperature protected The output current will reduce at high ambient temperature. IP43 protection When installed with the screw terminals oriented downwards. Screw terminals No special tools needed for installation. Input fuse (not replaceable)